A WTAE meteorologist told TribLive that in Western PA the normal winter lows are below freezing and the normal winter highs are above freezing, so you pretty much get a freeze-thaw cycle every day in winter. PennDOT refers to it as an aggressive, rapid cycle, and that’s the very same cycle that’s happening on your apartment parking lot every night.
We see freeze-thaw damage on apartment lots across the Pittsburgh area. Most managers see a pothole in March and treat it as a one-time event. A pothole is the last step of a process that started months earlier, usually with water you could not see.
What Happens Inside the Asphalt During One Cycle
Water gets into the pavement via the cracks, the worn areas, and the porous joints. It freezes at night and expands by about 9%, pushing the surrounding asphalt out. By the afternoon, the ice has melted, and you’re left with a slightly larger gap. The following night, water fills that gap and freezes again.
Temperature swings do more damage than the raw cold. A CBS Detroit meteorologist puts it this way: a winter that just stays frozen solid is far kinder to the pavement than a mild, wet winter with all sorts of temperature swings. That’s the sort of winter that Pittsburgh typically has.
The Five Stages of Freeze-Thaw Damage
The damage occurs in a sequence. The table below shows what each stage does and what you can see from the car park.
| Stage | What happens inside the pavement | What you see on the lot |
| 1. Binder weakens | Repeated cycles reduce the binder’s stiffness and fatigue resistance, and the air voids grow | Gray, dry, rough surface |
| 2. Stripping | Water breaks the bond between binder and stone, and this loss of adhesion continues with each cycle | Loose stones on the surface, raveling at the edges |
| 3. Cracks grow | Freezing water bursts the asphalt and widens and lengthens existing cracks | Wide cracks, alligator patterns |
| 4. Base heaves and softens | Frost heave lifts the pavement, and thawing weakens the soil below | Humps in late winter, soft spots in spring |
| 5. Pothole forms | Ice melts under the surface, leaving a void that collapses under traffic | A hole with broken edges |
Stage 4 definitely warrants our attention in this area. A KDKA report from one winter in Pittsburgh cited a local source who said there were 20 below-freezing days in a single January alone. That’s going to push the frost line right down into the ground. A deep frost line means the damage is going to be to the stone base underneath your asphalt, and base damage is vastly more expensive to repair than surface damage.
The Five Conditions That Must Line Up
Freeze-thaw damage won’t occur without all of the following conditions. Take away one and the damage will be greatly reduced.
- A water source, such as rain, snowmelt, or a downspout
- An entry path, such as a crack, a porous seam, or a worn surface
- Temperatures that cross 32°F repeatedly
- A base or subgrade that holds water and loses strength when it thaws
- Loads on top, including residents’ cars, trash trucks, and plow blades
Cracks at the paving seams provide water with an easy ingress route. We look at why the seams fail so early in What Causes Premature Cracking Along Apartment Parking Lot Paving Joints? The loads are just as important, and we look at that in Why Does Asphalt Wear Out Faster in High Traffic Areas of Apartment Parking Lots?
Where Apartment Lots Collect the Most Freeze-Thaw Damage
An apartment community makes its own weather. Buildings shade, roofs run off water, and hills send runoff downhill. The wet climate and varied topography of Western PA already give us a very strong cycle in that area, and your site is going to add some local hot spots. The table below shows where we see the damage first.
| Location on the lot | Why freeze-thaw hits harder there | What to look for |
| Below building downspouts | Roof runoff soaks the same patch of pavement all winter | Dark staining, early raveling, cracks fanning out from the downspout |
| North side of buildings | Shade keeps ice in place, and the edge of the shadow cycles daily | Heaving and cracks along the shadow line |
| Low spots near catch basins | Water pools around castings and curb cuts, which feeds the cycle | Puddles that last more than a day after rain |
| Bottom of slopes and ramps | Runoff from the hill concentrates at the base | Wide cracks, soft pavement, pothole clusters |
| Snow storage piles | Piles melt slowly, then refreeze on the pavement beneath them | Cracking in the same spot each spring |
| Dumpster pad aprons | Trucks load a wet, weakened edge | Cracked asphalt along the pad, sunken apron |
How We Diagnose Freeze-Thaw Damage Before We Quote
We walk the lot after a rain and again after a thaw, as water is the best indicator of where the pavement has failed. We take photos of the defects, we look at the soft spots, and we look at the drainage. If the base has softened, we’ll core the pavement to see how far down the damage goes. The Pavement Group’s contractor listing covers our work in asphalt repair, paving and overlays and concrete pavement repair, and every repair scheme starts with that diagnosis.
Frequently Asked Questions
What Can Apartment Communities Do in the Fall to Prepare Asphalt for Freeze-Thaw Season?
Start with the cracks, as every crack that’s open provides a route for water in. We clean and crack-seal in September or October on dry days, and crack sealing with rubberized asphalt is a standard treatment in the pavement preservation guidance. Then we clear the catch basins and check that the downpipes empty onto grass or into a drain rather than onto the pavement. If the surface has oxidized, we apply the sealcoat after the crack work, as the sealcoat forms a barrier to both water and chemical spills. Finally, we do the depression work, as those are the ones that hold water and will freeze and thaw in the same spot all winter.
Why Do Winter Pothole Patches Pop Out, and What Should Managers Do?
Winter patches pop out because the cold, wet material will never properly bond to the frozen, wet hole. A PennDOT district official told KDKA that they’ll often patch a pothole and then it’ll pop out the very next day. The hot mix asphalt plants close up for the coldest months, and a Greensburg public works director explained that the permanent repair has to wait until the plants reopen in early spring. We put in a winter patch to protect the public and their vehicles, and then we come back in the spring to saw cut the area, remove the wet material, and put in the hot mix. You have to budget for both visits, as the winter patch is just that: a temporary patch that buys you time and doesn’t in any way replace the final repair.
How Do You Fix Standing Water That Keeps Causing Freeze-Thaw Damage?
Standing water requires a drainage fix, as new asphalt laid over a puddle will fail once again. A pavement maintenance article points out that poor drainage continues to be a problem even after cracks and potholes have been repaired. We’ll mark the edge of the puddle after a rain and measure the depth to determine what slope the spot requires. On the majority of lots, we’re after a 1 to 2% slope to the nearest inlet. We achieve this by milling and repaving the low area or by adding a leveling layer. If the grade can’t be changed, we’ll extend the downspout leaders, clean the basins, or install a trench drain across the aisle.
How Do Managers Decide Between Patching, Overlay, and Full Replacement?
The decision is really down to how much damage there is. We patch where the damage is in discrete areas, and the base is firm to the probe. We mill and overlay where the surface has worn out but the base is still capable of carrying the load. If you have a large area heaving in winter and softening in spring, then the subgrade is almost certainly weakened, as a number of freeze/thaw cycles will work the upper subgrade soil to a soft state and reduce its density and stiffness. In that scenario, you remove the asphalt and the damaged base, rebuild with new stone, and repave, as a thin overlay would fail in a few seasons.
How Often Should Property Managers Inspect for Freeze-Thaw Damage, and What Should They Record?
We’d recommend three inspections per year: one in late October prior to the first freeze, one after the first major winter thaw, and one in April once pothole season is over. Cracks can change in the space of a week in this area as the cycle goes on almost daily through the winter, so we’d also advise a quick walk after any warm spell. At each inspection, you should record the position, size, and depth of every defect and take a photograph of it with a tape measure and the date clearly visible. Mark any standing water on a lot map, as the same puddles will tend to reappear. Those records will allow you to prioritize your repairs and give your contractor a very clear record to work from.
About the Author
The Pavement Group specializes in asphalt engineering, pavement maintenance solutions, and data-driven asset management for commercial, retail, and multi-family residential properties. Utilizing advanced structural pavement evaluations and capital planning transparency, The Pavement Group works directly with property managers to extend pavement lifecycles, eliminate liability risks, and optimize long-term infrastructure investments.