Water expands by some 9% when it freezes. A snowplow by itself is very rarely going to destroy a parking lot. The blade finishes what the trapped water did. A crack that’s been sitting under a snowbank all week will get progressively wider with each freeze. The next pass of the plow will catch the loose edge and pull it out.
We’re based in Wexford, PA, and assist property managers throughout the Pittsburgh area in protecting their lots. The plan we’re talking about here treats plow damage as a design issue that you resolve on paper prior to the first flake of snow. For example, last winter we worked with a 150-unit apartment community in Cranberry Township that had experienced repeated plow damage along their drive aisles and around the dumpster pads. After mapping out hazard zones, resetting utility covers, and updating their plow route map, they made it through the season with no major pavement repairs needed in the spring. Their property manager told us it was the first time in years their pavement had held up so well after winter.
Why Apartment Lots Lose Pavement to Plows Faster
Apartment communities pack a lot more hard points into each acre than a typical retail lot. You’ve got dumpster pads, speed humps, catch basins, curb cuts, ADA ramps, and mailbox kiosks all in the plow’s path. A lot of the Pittsburgh area complexes are on hillsides, so the drive aisles slope, and a blade corner will dig in at every change of grade. A plow driver who’s never seen the property is going to have no idea which of those are the fragile spots.
The table below shows where we see the plow damage and what we do about it.
| Location | What the plow does | Warning sign | Our fix |
| Manhole and utility covers | Catches the raised rim and rips the surrounding asphalt | Broken ring of asphalt around the cover | Reset the frame flush and repave the collar |
| Speed humps | Scrapes the crown and shears the top layer | Bare, shiny patches on the hump | Replace the hump surface with fresh hot mix |
| Curb cuts and ADA ramps | Hits the lip where asphalt meets concrete | Chipped concrete edge, loose asphalt | Cut back, repave, and restore compliant slopes |
| Dumpster pads | Pushes against the asphalt-to-concrete seam | Open gap between asphalt and pad | Seal the seam or replace the apron |
| Steep drive aisles | Digs in where the grade changes | Parallel gouges across the slope | Regrade and overlay the transition |
| Paver or concrete accents | Lifts edges and shifts units | Rocking pavers, cracked borders | Reset the units and specify a rubber blade edge |
Map the Plow Route Before the First Storm
A plow driver can’t possibly avoid a hazard that’s already buried in snow. The Fisher Plows commercial guide recommends that owners walk the property prior to plowing to identify any existing damage and to stake off entrances, curbs, sidewalks, and maintenance holes. We go one step further for the apartment community and produce a written plow route map. That map will show every hard point, every drain, and every spot where the plow is going to have to push snow.
Snow storage areas are just as important as the stakes. Meltwater has to have a route off the property, and as the Chief of Streets in Boston points out, it collects around utility hole castings and curb cuts, and that in turn feeds the freeze/thaw cycle. Snow has to be piled where the melt is going to run onto grass or a storm inlet, never across a drive aisle and absolutely not on top of a catch basin. Piles have to be kept off ADA ramps and fire lanes as well.
Walk the Lot Before Snow Flies
We’d recommend a 45-minute walk in late Oct/early Nov (before the first plowable storm). Take a phone, a can of marking paint, and a tape measure and check each of the following.
- Measure every utility cover that’s more than about half an inch above or below the surface and mark it for reset.
- Photograph every existing crack wider than a quarter inch, with the date visible.
- Mark the pavement edges where the asphalt meets the concrete, as those seams are where the blades will get caught.
- Stake the speed humps, the curb cuts, and the dumpster pad corners with tall reflective markers.
- Clear the catch basins of any debris so that the first thaw drains rather than pools.
- Mark any pothole or sunken area, as the damage underneath the snow could well be dangerous to both the plowmen and the residents.
Snow clearing guidance from the equipment manufacturers also advises crews to level the utility hole covers or at least to note any that are raised prior to plowing. We go one step further and reset the covers wherever we can afford to.
Match the Blade to the Surface
A steel cutting edge works fine on smooth, flat asphalt but is a bit of a struggle with hardware and accent surfaces. Rubber blades take the impact from manholes and expansion joints, which protects both the blade and the pavement. Pavers require a bit of care, and one commercial snow contractor noted that a standard blade can actually pull the pavers up or damage them.
Speed is also an issue. One manufacturer’s winter guidance is to limit speed to 14 mph when plowing. We’d suggest a far lower speed of 5 mph in the vicinity of speed humps, covers, and curb cuts. Slower blade will take the impact with far less force.
Put the Rules in the Plow Contract
A verbal promise is of no value if a plow comes along and tears out a speed hump in January. Put the rules into the agreement and attach the route map as an exhibit. The table below sets out the clauses that we would recommend to our apartment clients.
| Contract item | What to write | Why it protects the pavement |
| Cutting edge | Rubber or polyurethane edge near pavers, humps, and covers | Reduces impact at the weakest points |
| Speed near hazards | 5 mph or less around marked hard points | Lowers blade strike force |
| Hazard map | Contractor signs the map and reports missing stakes | Proves the contractor knew about each hazard |
| Snow storage | Named zones away from drains, ramps, and fire lanes | Keeps meltwater off the lot |
| Photo record | Dated photos before the season and after major storms | Separates old damage from new damage |
| Damage reporting | Contractor reports new damage within 24 hours with photos | Lets you repair before water gets in |
| Repair cost | Contractor pays for damage to any hazard on the signed map | Gives the contractor a reason to follow the map |
How We Help Apartment Communities Get Ready
The Pavement Group operates a national contractor network out of Wexford, PA. We do ADA parking compliance, asphalt paving and overlays, asphalt repair, and concrete pavement and sidewalk repair. We’ve been named a Top Contractor by Pavement Magazine in 2021, 2022, and 2023. We reset utility covers, we repair the edges, and we build the hazard inventory that goes into your plow contract. If a lot needs more than just patching, we design the overlay so the new surface is flush with every hard point. You can verify our contractor credentials, awards, and complete service list by visiting our website or contacting our office directly. We encourage you to check our background so you can feel confident you are working with a qualified and reputable team.
Call us in the fall, and your crew and your plow contractor will be starting the season with the same map.
Protect Your Apartment Community’s Pavement This Winter
Snowplowing is essential for keeping apartment parking lots accessible, but improper plowing practices can lead to cracked asphalt, damaged pavement edges, and costly repairs. The Pavement Group helps property managers maintain safer, more durable parking areas through professional pavement maintenance and repair solutions. Contact our team to discuss how we can help protect your property’s pavement throughout the winter season.
Contact Us TodayFrequently Asked Questions
How Should Property Managers Handle Asphalt Damage Around Apartment Parking Lot Gates?
Property managers need to think of gate damage as a stress and drainage issue, as the gates are essentially concentrating the stopping, starting, and turning forces onto a very small area of asphalt. The vehicle will be braking hard before the arm lifts and accelerating right after, so the surface will shove and ravel. The concrete footings alongside the lane provide a very hard edge that the plow blades will catch. We’ll cut out the failed area in a clean rectangle, remove the asphalt down to the firm base, tack the edges, and compact the new hot mix in lifts. We’ll always coordinate with the gate vendor prior to making any saw cut, as a saw cut can easily sever the detector loops that tell the gate that a vehicle is waiting.
What Causes Premature Cracking Along Apartment Parking Lot Paving Joints?
Premature joint cracking generally starts on paving day when the edge of one pass has had time to cool prior to the next pass coming up on it. The cold edge bonds very poorly, and the roller can’t compact that unconfined edge as densely as the center of the mat, so the joint is inherently more porous than the asphalt on either side of it. Water gets in that weak line, freezes, and the freeze-thaw action literally pries the joint open, which is exactly the pattern Roads & Bridges describe in their account of deferred cracking developing into potholes. Poor tack coat, segregated mix at the edge, and plow blades catching a slightly raised joint all accelerate the process. We seal the joints with rubberized crack sealant while they’re still narrow, and we cut them out and repave them once they’ve raveled or settled.
Does Road Salt Damage Apartment Parking Lot Pavement?
Salt is far more damaging to apartment lots in that it attacks the asphalt directly rather than just through the freeze-thaw cycles that the asphalt endures. It lowers the freezing point of water so the snow melts at lower temperatures, and the meltwater then refreezes overnight, and the cycle is repeated. Each cycle drives more water into the cracks. Winter is the time when freeze-thaw cycling, moisture, and plowing all combine to wear the pavement down. Concrete dumpster pads, curbs, and sidewalks are far more susceptible than asphalt, as salt scars the surface and flakes the top layer away. We tell the managers to use salt very sparingly, to sweep up the excess in the spring, and to fill in any low spots so that the meltwater will just run off the lot.
How Should Apartment Communities Manage Resident Parking During Snow Plowing?
Parked cars force the plow drivers into very tight angled passes, and the blade corners will dig into the asphalt on those turns. We should designate an overflow zone and require residents to park their vehicles in that zone during a snow event. Send the text/app notice 12-24 hours prior to the storm and have matching signs at the entrances to the lot that correspond to the lease language. Be sure to check your township’s ordinances prior to enforcing any towing, as the rules around private lot towing can vary from township to township in the Pittsburgh area. After the storm, we’d suggest the plow crew clear the vacated stalls first so the residents can come back to a clean, level surface.
Does Sealcoating Help Apartment Parking Lots Survive Plow Season?
Sealcoating helps, but it does not stop a blade from gouging the surface. A sealcoat gives protection against UV radiation, water infiltration, chemical spills, and traffic wear, which slows the aging that makes asphalt brittle. We always fill and seal cracks first, because sealcoat laid over open cracks does not keep water out. We apply it only when air and ground temperatures stay above about 50°F, so it cures properly, which means spring or early fall in Western Pennsylvania. Many apartment communities reapply sealcoat every two to three years, and we restripe the lot afterward so parking stalls and fire lanes stay clear.
About the Author
The Pavement Group specializes in asphalt engineering, pavement maintenance solutions, and data-driven asset management for commercial, retail, and multi-family residential properties. Utilizing advanced structural pavement evaluations and capital planning transparency, The Pavement Group works directly with property managers to extend pavement lifecycles, eliminate liability risks, and optimize long-term infrastructure investments.